Also all of Oakwood is down.
Went to oakwood – power is good, swapped SX modules, both are fine.
Went to maplewood, swapped SX modules, both are good, however, they are now both working – go figure. If the link from maplewood goes out again – replace switch. If link to PP goes out, replace SX module.
Checked for loose fiber – didn’t find any.
Users were unable to imput data via the keypads.
Internet outage –
A problem with the Ntelos network caused the problem. At 7:20 they had no estimate of when the outage would be resolved.
Utilization was 86%, and the server show typical signs of being hung. Rebooted and did not load Sophos Sweep, but did load NovaNet.
Debug screen with “multiple abends on processor 0” message at top. Re-enabled logical processors from BIOS setup and restarted. Server hit 46% utilization and became unresponsive within 10 min. Swapped ACPIDRV for MPS14 in STARTUP.NCF. Server is now back to original config, and processors 1-3 are offline.
Novell server ST hung at 46% CPU. When the second processor was stopped, CPU was 93%. No idea why this happened. All else seemed to be normal. Sweep and novastor was running. Server had to be powered off to get it operational again.
ST server needs to be taken down to disable hyperthreading.
_______________
Logical processors were disabled in the bios. Startup.ncf was modified to remove acpidrv.psm and replaced that with mps14.psm. This should allow multiprocessor function and not allow hyperthreading of logical processors.
Dan
The calendar server was unresponsive via the network or the console. A “spurious interrupt” message appeared on the console. After a reboot, everything appears fine.
FSAPPS server needs to be rebooted to install new drivers for the NIC.
FS server needs to be rebooted to install new drivers for the NIC.